GIAC Stage 3 K04 software upgrade

$631.25

Stage 3 K04 adds horsepower, torque and more throttle response throughout the power band. The requirements to run this calibration are: K04 exhaust intercooler intake HPFP

SKU: GIAC_930 Category: Tag:

Description

Upgrade your Audi TT MK2 2006 – Present, 2.0 Turbo FSI with GIAC Stage 3 K04

  • Horsepower gain: 197 HP -> 285 HP* (pump mode)/320 HP** (race mode)
  • Toque gain: 207 Ft-Lbs -> 310 Ft-Lbs* (pump mode)/330 Ft/Lbs** (race mode)

Optional switcher with stock, race, kill, valet and/or firewall mode may be available for in-car map switching starting at $220 (contact us for details)

Stage 3 K04 adds horsepower, torque and more throttle response throughout the power band. The requirements to run this calibration are: K04 exhaust intercooler intake HPFP

We highly recommend the car to be in perfect mechanical condition. Availability is dependent on the ECU version of the car (listed below) and if not know we will be glad to check it (complementary) if you visit us with the car. HP and torque figures are average engine estimates. They are derived from wheel power and acceleration testing. Results may vary depending on a variety of factors. These are transmission, vehicle health, operating conditions, temperatures and other environmental conditions, dyno type, dyno setup, fuel grade, other variables, and modifications.

* 91 octane fuel compatible. 93 octane fuel for optimum results.

** 100 octane fuel compatible. 105 octane fuel for optimum results. Optional switcher or remapping required.

This product is valid for the following car Audi TT MK2 and the following ECUs (feel free to stop by our shop to check yours): 8J0907115; 8J0907115B. A GIAC DSG flash is needed for optimum gains but the program can be run without one.

Hand Held Flashloader Switcher

GIAC’s Flashloader Handheld Switcher allows users to switch between GIAC-tuned software programs with the touch of a button. The product is a pocket-sized, hand-held device that plugs directly into the OBD port. It uses serial flashing technology and requires no additional hardware within the DME. To use the switcher, you should select the desired mode with the touch buttons. Cycling the ignition will save the new mode to the ECU’s memory and retain its state until switched again.

How to purchase? 

Pictures used for marketing purposes only, actual product may vary.

Reviews

There are no reviews yet.

Be the first to review “GIAC Stage 3 K04 software upgrade”

MakeModelChassisEngineDetails
AudiTTMK II (2008-2013)2.0TFWD
AudiTTMK II (2008-2013)2.0TQuattro